Replace the green bottom lid
This sensor is for direct current (DC) measurements only !!
Open the machine, locate the battery and look for plus and min poles.
Attach the sensor to one of the cables attached to the plus or the minus pole of the battery.
Only one sensor is needed. It does not matter which cable you choose.
Make sure you install the sensor correctly:
• Either on the minus pole wire: arrow on the sensor points towards the battery.
• Or on the plus pole wire: arrow on the sensor points away from the battery.
When installing on the positive pole wire, the
arrow on the outside of the sensor is pointing
away from the battery.
When installing on the negative pole wire, the
arrow on the outside of the sensor is pointing
towards the battery.
Install in the machine
www.sensolus.com | info@sensolus.com
June 15, 2023 1:59 PM
Open the sensolus smartphone
app. Select the tracker from the
asset list. Click “link sensor” at the
bottom of the page in the advaced
section.
3. Link the sensor to the tracker with the mobile app
Make sure you are working with the latest version of the app installed on your phone.
Click the pair sensor button
Scan the the QR code of the the
sensor, the sensors slots will be
automatically assigned
You will see that the sensor
is linked. Both charging and
uncharging slots are filled.
Select the sensor you want to
adjust the threshold values for.
4. Adjust the threshold values for testing purposes
Make sure you are working with the latest version of the app installed on your phone.
Click the settings wheel
Enter the forward and backward
current threshold. Click on the
save icon to store the settings.
To know how to define the
thresholds, consult the Sensolus
documentation centre.
Open the sensor manager in the
sensolus application.
ADMINwww.sensolus.com | info@sensolus.com
June 15, 2023 1:59 PM
Keep in mind.
• Do not expect to count the time of short cuttent flows since the measurement interval is 30
seconds, and the time reporting resolution is in minutes.
• Do not expect to see live current measaurement (or any current measurement) in the platform.
• Do not expect to see current vs time in a graph in the platform.
• The sensor does not measure voltages or usage of AC generators.
• The sensor cannot measure any alternating current (AC).
• The sensor cannot be use outdoors since the sensor is not IP rated.
• Do not drop the sensor (these clamps are made with fragile ferrite cores inside and will not survive a
drop).
• Do not hit the sensor them, these clamps are not IK rated.
• When you put the + and the – wire into the clamp at the same time, as the positive and negative
magnetic fields (induced by the current flow) will cancel each other out., resulting in always
measuring nothing!
